Key Features:

• Colour-fast - there is no 'bleeding' at the edges when ironing over seams.
• The covering for light constructions.
• Wherever minimum weight is demanded, wherever weight has to be reduced to its limits, ORACOVER® AIR is the product to be applied.
• Whether indoor flyers, park flyers, blimps or airships are to be built, ORACOVER® AIR will do the covering job.
• In contrast to regular ORACOVER, ORACOVER AIR has no adhesive layer.
• The hotmelt adhesive is to be brushed onto the surface.
• ORACOVER AIR OUTDOOR (approx.23 µm), the best choice for more solid light aircraft, park flyers, etc. ORACOVER® AIR OUTDOOR has not only proved itself as covering film for model airplanes, but becomes more and more popular as base material for model sails.

RECOMMENDED ACCESSORY:

• ORACOVER AIR Hotmelt Adhesive ORACOVER AIR Adhesive (100 ml) Unstable wood fibres can become insecure and can rip off due to the weight.
• The consequences would be wrinkling and in the worst case the complete peeling off of the fabric.
• Our tip: For an optimal pre-treatment of your wood surface we recommend to coat the surfaces to be ironed with ORACOVER AIR Hotmelt Adhesive.
• The ORACOVER AIR Hotmelt Adhesive penetrates the wood and sticks together the loose wood fibres of the heartwood. With that you reach an excellent three-D adhesion of the ORACOVER AIR film with the surface.
• With the ORACOVER AIR Hotmelt Adhesive you do not need a further pre-treatment of the wood anymore.

Application of the ORACOVER AIR Hotmelt Adhesive:

• 1. Sand your wood completely and remove the swarf (vacuum).
• 2. Stir up well the contents of the tin.
• 3. Apply the ORACOVER AIR Hotmelt Adhesive 1 – 2 times thinly and evenly by using a brush.
• 4. Let the adhesive dry overnight, however at least 10 hours. (Please do not resand).
• 5. Cover your model as always with the thermal shrink fabric covering ORACOVER AIR.
• Productivity: approx. 1 tin / 1m² Unsuitable for surfaces which are not resistant to organic solvents.
• ORACOVER AIR SPECIAL THINNER If our adhesives should dry a little bit in open containers, the adhesive can be adjusted again to brushing viscosity with the corresponding thinner.