Skip to main content
  1. Home
  2. More
  3. Electronics
  4. Beier Electronics
  5. Expansion Boards and Switching Modules
  6. AKL-8-K Terminal block (Constant current)
 

BEIER AKL-8-K Terminal block (Constant current)

AKL-8-K Terminal block (Constant current)

In stock

Click to enlarge

BEIER AKL-8-K Terminal block (Constant current)

Stock code AKL-8-K

Brand  BEIER

  Good stocks
Available for same day despatch Mon–Fri if ordered before 2pm, when possible
£19.00Each
 
lt;pgt;Beier AKL-8-K Terminal block (Constant current)lt;/pgt; lt;pgt;Descriptionlt;br /gt;The AKL-8-K terminal clamp enables convenient connection of LEDs to the switching outputs of the following modules:lt;br /gt;Sound module USM-RC-3lt;br /gt;Mini sound module MSM-1lt;br /gt;Sound speed controller SFR-1lt;br /gt;Double sound speed controller SFR-1-Dlt;br /gt;Sound speed controller for Torro / Taigen and Heng Long SFR-1-HLlt;br /gt;Speed controller UFR-1230lt;br /gt;Double speed controller UFR-1230-Dlt;br /gt;Light modules LM-IR-8-1, LM-IR-16-4 and LM-BT-16-4lt;br /gt;The AKL-8-K is plugged directly onto the module using the ribbon cable.lt;/pgt; lt;pgt;The AKL-8-K terminal clamp provides 8 current-limited outputs for direct connection of LEDs.lt;br /gt;Each of the 8 outputs delivers a constant current of approximately 20 mA (typical current for standard LEDs), over a wide range of supply voltage, allowing direct connection of LEDs. No series resistors are required for the LEDs.lt;/pgt; lt;pgt;It is also possible to connect multiple LEDs in series. The current remains constant at approximately 20 mA. However, it should be noted that the battery voltage must be minimum 2 V higher than the series connection requires. For example, if 3 LEDs with a forward voltage of 3 V each are connected in series to one output, the battery voltage must be at least 11 V (3 x 3 V + 2 V).lt;/pgt; lt;pgt;The negative-switching outputs 1-8 and 9-16 are available directly on a spring-loaded terminal at the connection terminal.lt;br /gt;The common positive pole is connected to terminals 9 and 10.lt;br /gt;Internally, the positive pole is connected to the positive line of the supply voltage (battery +).lt;/pgt; lt;pgt;The outputs can also be dimmed using the "Intensity" setting in the Sound/Drive or LM Teacher.lt;/pgt; lt;pgt;Technical Datalt;br /gt;Voltage:    5 – 30 V (at least 2 V more than the forward voltage of the LEDs)lt;br /gt;Output current:    approximately 20 mAlt;br /gt;Terminal assignment:    Terminal 1 to 8: Switching outputs 1 to 8 and 9 to 16 (minus switching)lt;br /gt;Terminal 9 to 10: Positive pole of the supply voltagelt;br /gt;Connecting cable:    10 pin ribbon cable, 20 cm longlt;br /gt;Size:    37 x 29 x 17 mmlt;br /gt;Weight:    20 glt;/pgt;
 
Back to list
 
Back to list
 

iconMore